Shotgun Bill’s Scoop® S/B Chevy Tunnel Ram Intake/Carb Kit

The Shotgun Bill’s Scoop® tunnel ram kit gives you two manual choke 500 cfm Edelbrock carbs, the famous Shotgun Bill’s Scoop® air intake scoop, carb linkage and Edelbrock street tunnel ram intake (3500-7500 rpm).

Designed for 1957-1986 302-327-350-400 c.i.d. small-block Chevy V8s operating below 7500 rpm where low-end torque is not a prime factor. Great for engines with slightly modified or aftermarket heads. Applicable to street machines, street rods, pro street and marine.

Will NOT work with 1987-up cast iron heads or HEI distributors. See Notes for important install notes.

Charts

925-19905 Instructions (PDF)

Specs

19″ total height from block to top of manifold
Port exit dimensions: 1.12″ x 2.12″
Air Scoop is 20-1/2″ long, 11-1/4″ wide, 6″ tall
5-1/4″ diameter air scoop intakes
Manifold Height at Front: 9.00″
Manifold Height at Rear: 9.50″
Carburetor height is 3-3/8″ from base surface to upper neck base where air cleaner fits
Distance from carb center to carb center: 8.875″
Single carb spacer included to level the carbs for proper air cleaner / scoop fitment.