Bowler Performance Lock-Up Control Modules 5102000

Bowler Performance lock-up control modules come complete with everything needed to seamlessly control your torque converter lock-up. Converter lock-up will occur 8 to10 seconds after 4th gear engagement, allowing enough engine rpm gain before lock-up, giving your engine more performance and providing a better feel to lock-up.

Bowler’s lock-up modules only require one 2 amp fused 12 V wire to operate. No vacuum switch is necessary allowing these modules to function correctly with all types of engines, and there are no bulky boxes to hide or mount. The control modules have the GM 4-prong connector integrated onto the control board, and are epoxy coated to stay protected against the elements. Choose the kit designed for your transmission.

Kits include:

* Lock-up control module
* Internal wiring harness with lock-up solenoid and mounting studs
* Pressure switch
* Pan gasket
* New transmission filter
* Case pass through connector
* Brake light switch—standard that has a normally closed switch (for your lock-up module) and a normally open switch (for your brake lights). The brake switch does not have to be installed for the lock-up module to function, but will allow the driver to tap the brake to un-lock the converter at any time. If you are going up an incline and need a few more rpms to get up that hill, just tap the brake, and the lock-up will turn off and not re-engage for approximately 8 seconds. For those with a high-gear ratio and late down shifts who experience a chug of the motor due to the lock-up converter still being engaged; the switch will eliminate this concern.